This ProClip Vehicle Center Mount is a custom made car specific mount. The mount attaches to the center area of the car dashboard. It provides the perfect mounting platform for your device holder so you don't have to fumble around for your device anymore. The ProClip Center Mount is a very sturdy mounting bracket that clips tightly into the seams of the dashboard. No drilling holes or dismantling of the dashboard is required, simply clip on in seconds.
Device Holder NOT included, sold separately.
Comes with a pre-drilled hole pattern for device attachment (might not be shown in photo). This is a suggested placement pattern only. A device holder can easily be attached anywhere on the face plate.
Notice: Consider how the device, or horizontal position, will fit the location and could interfere with other vehicle functions.
- Provides the perfect mounting platform
- Clips into the seams of the dashboard
- Easily attach a device holder to the mount
- Secure fit within easy reach from the driver's seat
- No holes or damage to your dashboard
CompatibilityCalifornia Prop 65 Warning
- Chris C.Verified BuyerRated 5 out of 5 stars5 months agoGreat phone holder
Did alot of research to find a solid holder that wouldn’t be in my face and would be a solid interface between my phone and my car
This was perfect fit for both my Sienna and Highlander, and easy to install as well
Well worth the cost
Love 2 piece set up as this helps if change phone or carsAge Range 55 - 64Customer Frequency First-Time Customer
- Eric G.Verified BuyerRated 5 out of 5 stars10 months agoVery nice
The wife loves it.Age Range 45 - 54Customer Frequency Repeat Customer
- Daniel G.Verified BuyerRated 5 out of 5 stars1 year ago2008 Toyota Sienna
Easy installation. Very sturdy which was my concern when I first looked at this product. I wanted my phone to the right of my steering wheel so I finally went with this version and am glad I did. I do recommend a test fit prior to removing the film covering the pads simply so you realize exactly where to squeeze the clip so it fits smoothly into place and is recessed into the air vent prior to the sticky pad touching the vent. That is what I did and the installation was easy. The only thing I would recommend is that if your hand strength isn't that great then have someone on standby who can do it for you. With that said, it wasn't that hard to do. As I recall, the top is just put into place and then you squeeze/squish the bottom clip up towards the top clip and guide into the air vent and release once the edge of the recessed clip with the glue pad is in place. I then reached around the back of the clip and pushed on the upper and lower pads out of paranoia but I don't think it was necessary. All of the instructions are in the bag with the clip. I did take a brush to my air vent where the pads will sit prior to installation of the clip. I then installed my phone holder (iPhone 7 plus with larger case) and it has held the phone perfectly. I would definitely recommend this product if you're searching for a phone holder that will work with the crazy curves of a Toyota Sienna.
A Better Way to Mount Your Phone
Don't settle for cheap and flimsy one-size-fits-most phone mounts that wobble in your vents or suction cups that consistently fall off. There's a better, more solid way to mount your phone.
The Mounting Base
Our exact-fit mounting bases are made specifically for most car and truck models. The mounts easily snap into the seams of the dashboard for a solid and secure fit so you can mount your phone with confidence.
The Device Holder
Our holders are designed specifically for your smartphone, GPS, or other mobile devices. Phone holder options can fit phones with or without cases, and charge wirelessly or with charging cables.