Great for use with navigation software. Works in an upright position and horizontal position. This Holder has a plush coating. This is the choice for you who are using your iPhone with navigation and easily want to switch between an upright position and a horizontal position - simply turn the holder into desired position. The holder provides a more secure upright and horizontal position than a standard holder. A pass through connector is permanently attached to the Holder base so you can connect any cable e.g. Audio/AUX/Data/Power/Sync/GPS/USB/ Video Cables etc. that would fit directly into the bottom of the device to the base of the Holder and pass the connection up into your device. You are then able to leave the cable connected to the Holder and you can now easily dock/undock your device without having to manually connect/disconnect your cable. You can also easily switch between cables. The cable clicks into the Holder and releases by pressing on the buttons on each side of the cable plug.

About the Holder A pass through connector is permanently attached to the Holder’s base. The device, when slid into the Holder, connects to the male plug. This way you don’t have to disconnect the cable from the device every time you bring it with you! The female part of the connector is accessible at the bottom part of the Holder's base. This way you can easily attach, and switch between, any kind of cable that would fit directly into the bottom of the device e.g Audio Cables, Charging Cables, Data Cables, Sync Cables, GPS Cables etc. About Our Tilt Swivel The Tilt Swivel on the back of the Holder can tilt 15 degrees in any direction and swivel 360 degrees. The Tilt Swivel provides easy adjustment of your handhelds position for better viewing, and extends the Holder from the Mount by 20mm / 0.78in. You can also adjust the Holder to avoid unnecessary light reflection. (The Holder shown in the picture to the left is attached to a demo ProClip Mount) The Tilt Swivel Base Plate on the back of the Tilt Swivel can be attached to any flat surface or mounting brackett. The base plate comes with 6 pre-drilled holes; 2 holes in a center line and 4 holes in an almost square like pattern to accommodate the AMPS hole pattern. Enclosed in the packaging are 4 self tapping screws and 4 machine screws with nuts. Dimensions of base plate: 50mm/1.96inches x 42mm/1.65inches. The 4 holes in the corners have a diameter of 0.5mm, and the self tapping screw holes in the center have a diameter of 0.3mm. Keep two devices on the same mount or use one at a time If you have two devices you would like to have next to each other on your dashboard you may be able to have them on the same mount as shown in the General Picture to the left, by using our Horizontal Extension Plate. You can also move a device/holder from car to car (mount to mount) or switch between to devices/holders on the same mount by using our Move Clip System. Please see the product category, Mounting Options, to the left to learn more about these options. Keep all your devices on the dashboard If you have more than one device you would like to have on your dashboard, we may have the solution. Usually we have 2 or more mounts for each vehicle model so you can have all your devices securely attached on your dashboard. Many of todays customers order two or more mounts and holders - usually one for their mobile phone and one for their Handheld and/or Music Player like the General Picture below illustrates.

Make Model Apple iPhone 4 / 4S WITHOUT Cases AT&T Apple iPhone 4 / 4S WITHOUT Cases Make Model Sprint Apple iPhone 4 / 4S WITHOUT Cases Verizon Apple iPhone 4 / 4S WITHOUT Cases

Click here to see/print detailed installation instructions