This Adjustable Holder with Pass-Through Connector is designed for the Apple iPhone and Touch with silicone type cases e.g. iSkin, Jam Jacket, Speck, XtremeMac, Showcase etc. The Holder will adjust from a width of 2.3 inches/60mm to 3.2 inches/82mm and allows you to connect any cable e.g. Audio/AUX/Data/Power/Sync/GPS/USB/ Video Cables etc. that would fit directly into the bottom of the device to the base of the Holder and pass the connection up into your device. You are then able to leave the cable connected to the Holder and you can now easily dock/undock your device without having to manually connect/disconnect your cable. You can also easily switch between cables. The cable clicks into the Holder and releases by pressing on the buttons on each side of the cable plug. The Holder angles 15 degrees for optimal viewing. Easily slide your device in/out of the holder. No more fumbling around for your device. Provides for safer driving when viewing, accessing and operating your device in your vehicle.

About the Holder Tired of streching over the floor console in your car to reach into the glove compartment and connect/disconnect your iPod from your stereo integration cable? The Holder with Pass-Through Connector allows you to keep the iPod conveniently on the dash, within easy reach, by allowing attachment of your stereo cable or any other cable you may have to the Holder. This connector is compatible with the iPhone, iPad and iPod (touch, classic, video), and iPod nano (1st, 2nd, 3rd generation). The Pass-Through connector passes through all 30 pins from/to the device. About Our Tilt Swivel The Tilt Swivel on the back of the Holder can tilt 15 degrees in any direction and swivel 360 degrees. The Tilt Swivel provides easy adjustment of your handhelds position for better viewing, and extends the Holder from the Mount by 20mm / 0.78in. You can also adjust the Holder to avoid unnecessary light reflection. (The Holder shown in the picture to the left is attached to a demo ProClip Mount) The Tilt Swivel Base Plate on the back of the Tilt Swivel can be attached to any flat surface or mounting brackett. The base plate comes with 6 pre-drilled holes; 2 holes in a center line and 4 holes in an almost square like pattern to accommodate the AMPS hole pattern. Enclosed in the packaging are 4 self tapping screws and 4 machine screws with nuts. Dimensions of base plate: 50mm/1.96inches x 42mm/1.65inches. The 4 holes in the corners have a diameter of 0.5mm, and the self tapping screw holes in the center have a diameter of 0.3mm. Keep two devices on the same mount or use one at a time If you have two devices you would like to have next to each other on your dashboard you may be able to have them on the same mount as shown in the General Picture to the left, by using our Horizontal Extension Plate. You can also move a device/holder from car to car (mount to mount) or switch between to devices/holders on the same mount by using our Move Clip System. Please see the product category, Mounting Options, to the left to learn more about these options. Keep all your devices on the dashboard If you have more than one device you would like to have on your dashboard, we may have the solution. Usually we have 2 or more mounts for each vehicle model so you can have all your devices securely attached on your dashboard. Many of todays customers order two or more mounts and holders - usually one for their mobile phone and one for their Handheld and/or Music Player like the General Picture below illustrates.

Make Model Apple iPhone 1st Gen. Apple iPhone 2nd Gen. (3G) Apple iPhone 3G Apple iPhone 3GS Make Model Apple iPhone 3rd Gen. (3G) Apple iPhone 3rd Gen. (3GS) AT&T Apple iPhone 3G AT&T Apple iPhone 3GS

Click here to see/print detailed installation instructions