Search by item No:

ABOUT SSL CERTIFICATES

ProClip Adjustable Console mount with Tilt Swivel

General Picture of an Adjustable Console mount with Tilt Swivel

Item #: 830515

Price: USD $34.99

Adjustable within the range of 56-84 mm/2.3-3.3 inches.
All ProClip Mounts come with pre-drilled holes in the face plate. Read more about the different hole patterns in the face plate below.

Product Info

How to Install

Compatibility

This easily self-install Console Mount is adjustable within the range of 56-84 mm/2.3-3.3 inches and attaches along side the console sidewall, providing a very sturdy and tight fit. The console sidewall measures from the top of the console to the bottom of the console by the floor. Due to the adjustable feature it fits many other vehicles as well. Average installation time is 30 sec. to 2 minutes. (See confirming article in The New York Times) See detailed installation instructions including pictures below. No dismantling of your dashboard is required and there is no damage to your vehicle’s interior! The ProClip Mount is made of ABS plastic and is heat and cold resistant.

A Tilt Swivel is attached on the top of the ProClip Mount. It provides for easy adjustment of your devices position for better viewing. You can also adjust to avoid unnecessary light reflection. The Tilt Swivel can be tilted/angled 15 degrees in any direction and swivel 360 degrees.

Note: If you are planning to use this mount with a ProClip Holder with Tilt Swivel, please be aware that you then will have two tilt swivels on top of each other. This will provide an unsteady/wiggly situation and is not recommended. You can avoid this by ordering the Adjustable Console Mount without the Tilt Swivel instead (item # 830510). To select the Adjustable Console Mount (item # 830510), use the back button on your browser to get back to the search result page and scroll down until you see it.

The Tilt Swivel face plate hole patterns
The Tilt Swivel face plate has several hole patterns – one with four holes in a center line and one that have four holes in a square-like pattern to accommodate the AMPS standard. The screw in the center controls the tilt and swivel feature. Loosen the screw and adjust the face plate to desired position. Tighten the screw to lock it in place.

What can you attach to the ProClip Mount

Onto the ProClip Mount you can attach any type of holder for your device i.e. a Mobile Phone, PDA, Handheld, GPS, Digital Music Player, Navigation Monitor, Multimedia Monitor, Handsfree kit, Two-way radio etc. as shown in the General Picture to the left.

For best possible use of your device in your vehicle, you’ll also want to select a Holder for your device. Select the appropriate product category to the left.

ProClip Adjustable Console mount with Tilt Swivel

The Tilt Swivel face plate hole patterns

What can you attach to the ProClip Mount