Choose your country.

Our product information is specific to your location.

close menu

We believe you are visiting us from:

Ship-to country
United States

This will automatically be set as your ship-to country if you take no action to change it.

Your Vehicle Not Configured Set up now Your Device Not Configured Set up now

Tilt And Swivel Mount Inserts

Tilt And Swivel Mount Inserts

If only you could tilt your device screen just a little bit, you could get that blinding glare from the sun out of your eyes. If your device holder had a swivel, you could use your mobile device in both portrait and landscape modes.

Our tilt and swivel mobile mounting accessories help you to angle and extend your device for optimal viewing. These mount inserts fit snuggly between your vehicle mount and your device holder.

  • 4 Results
Item 215500
This Tilt Swivel is made for use with holders for heavier devices.
  • For use with heavier devices e.g. tablets, bar code scanners, two-way radios, etc.
  • Tilts 15 degrees
  • Swivels 360 degrees
$19.99 USD
Item 215453

This Tilt Swivel is made for use with ProClip custom device holders. The Base plate uses the AMPS hole pattern for use with ProClip vehicle mounts.

  • Replacement tilt swivel for use with ProClip custom device holders (not for adjustable holders)
  • Tilts 15 degrees
  • Swivels 360 degrees
$12.99 USD
Item 213019
Angle your holder/device for a better viewing position. Same as item no. 215453 above but it extends from center to better avoid interference between your device and dashboard buttons, gear shift etc.
  • Angles/tilts 15 degrees
  • Swivels 360 degrees
  • Extends 1 inch/ 2.54 cm
  • Face plate has AMPS and other hole patterns to accommodate most holders/devices and car kits
$15.99 USD
Item 215122
  • For holders with vertical mounting holes on the face
  • Angles/tilts 15 degrees
  • Swivels 360 degrees
  • Face plate for holders that have two vertical mounting holes
$12.99 USD
  • 4 Results