Switch between two or more devices/holders using only one dashboard mount. The Move Clip system is basically a Female Plate with a wide V-slot and a Male Plate that is shaped to fit into the V-slot in the Female Plate. The Male Plate slides into the Female Plate. The Female Plate attaches to a mounting bracket or any kind of flat surface. The Male Plate attaches on the back of your device or on your device holder/cradle. The Move Clip System can be used in vehicles, boats, RVs etc. It can also be attached to walls, computer monotors etc. You can have as many of each part as you want to. This Move Clip Kit is ment for switching between two devices using one dashboard mount etc. Dimensions: 50 x 42 x 5 mm / 1.97 x 1.65 x .19 inches

The Move Clip system is basically a Female Plate with a wide V-slot and a Male Plate that is shaped to fit into the V-slot in the Female Plate. The Male Plate slides into the Female Plate. The Female Plate attaches to a mounting bracket or any kind of flat surface. The Male Plate attaches on the back of your device or on your device holder/cradle. The Move Clip System can be used in vehicles, boats, RV's, walls, computer monitors etc. You can have as many of each part as you want to. This Move Clip Kit is ment for switching between two devices using one dashboard mount etc. If you want to move one device between two vehicles, you should order the Move Clip Kit with 2 Feamle Plates and 1 Male Plate (item No.: 213099) If you need additional plates they can be ordered separately. (Female Plate: Item No.: 213091 and Male Plate: Item No.: 213092) All the parts are listed under the category Mounting Accessories The Female Plate attaches to a flat surface i.e. a dashboard mount as shown in the picture. The Female Plate comes with two strips of double adhesive tape on the back and two screws. You can attach the Female Plate to the flat surface by using either screws, glue or both. The Male Plate attaches to the back of your Holder (recommended) or directly to the back of your device as shown in the picture below. The Male Plate comes with two strips of double adhesive tape on the back and two screws. You can attach the Male Plate to the holder by using either screws, glue or both. If you are attaching the Male Plate on to the back of your device you can only glue it on. The adhesive tape is very strong and is enough for it to attache properly. The tape is still easy to remove if done the right way. It doesn't leave foam like pieces from the tape when removed. If the Male Plate is attached on to the back of your device, you may also order a Tilt Swivel Mount to go between the Male Plate and the Dashboard Mount as shown in the picture. The Swivel will allow you to adjust the angle of your device for better viewing. You will find the Tilt Swivel Mount by selecting the category Mounting Accessories on the left side of the page.

Make Model ProClip Move Clip Make Model

Click here to see/print detailed installation instructions