See ProClip's video on how to fit your holder to your device.
Benefits
This Adjustable Holder with Tilt Swivel was originally designed for the Apple iPhone and iPod Touch using a shield, skin or case including the OtterBox defender case. The Holder will also fit other devices with a skin or case e.g. Smart phones, BlackBerry, PDA, MP3 players etc., but the buttons and ports on the side of these devices may be covered up and the fit may not be a 100%. However, the Holder will still be very convenient to use
The Holder width can be adjusted from 2.5 inches (63mm) to 3.3 inches (85mm)
Adjustable to your device
Holds device securely
Keeps your device within easy reach
Easily slide device in and out
Keeps your device upright for better cellular/GPS reception
Neat and discreet design blends well with vehicle's interior
Holder can tilt 15 degrees in any direction and swivel 360 degrees
Made of heat and cold resistant ABS plastic
Order This Product
Item #: 511165
Price: USD $39.99
Product Info
How to Install
Compatibility
This Holder is adjustable and is intended to be used for the Apple iPhone 4 with most common Silicone and Shell cases. Including the 2nd Gen. Apple Bumper and OtterBox Cases. DOES NOT WORK with the Ballistic case.The Holder tilts/angles 20 degrees for optimal viewing. It keeps your device in an upright position for better reception. Easily slide your device in/out of the holder. No more fumbling around for your device. Provides for safer driving when viewing, accessing and operating your device in your vehicle.
About Our Tilt Swivel
The Tilt Swivel on the back of the Holder can tilt 15 degrees in any direction and swivel 360 degrees. The Tilt Swivel provides easy adjustment of your handhelds position for better viewing, and extends the Holder from the Mount by 20mm / 0.78in. You can also adjust the Holder to avoid unnecessary light reflection. (The Holder shown in the picture to the left is attached to a demo ProClip Mount)
The Tilt Swivel Base Plate on the back of the Tilt Swivel can be attached to any flat surface or mounting brackett. The base plate comes with 6 pre-drilled holes; 2 holes in a center line and 4 holes in an almost square like pattern to accommodate the AMPS hole pattern. Enclosed in the packaging are 4 self tapping screws and 4 machine screws with nuts. Dimensions of base plate: 50mm/1.96inches x 42mm/1.65inches. The 4 holes in the corners have a diameter of 4 mm, and the self tapping screw holes in the center have a diameter of 3 mm.
Keep two devices on the same mount or use one at a time
If you have two devices you would like to have next to each other on your dashboard you may be able to have them on the same mount as shown in the General Picture to the left, by using our Horizontal Extension Plate. You can also move a device/holder from car to car (mount to mount) or switch between to devices/holders on the same mount by using our Move Clip System. Please see the product category, Mounting Options, to the left to learn more about these options.
Keep all your devices on the dashboard
If you have more than one device you would like to have on your dashboard, we may have the solution. Usually we have 2 or more mounts for each vehicle model so you can have all your devices securely attached on your dashboard. Many of todays customers order two or more mounts and holders - usually one for their mobile phone and one for their Handheld and/or Music Player like the General Picture below illustrates.
;)
;)
;)
