Keeps your device upright for better cellular/GPS reception
Neat and discreet design blends well with vehicle's interior
Holder can tilt 20 degrees in any direction and swivel 360 degrees
Made of heat and cold resistant ABS plastic
Product Info
How to Install
Compatibility
Always keep your battery fully charged with this high quality custom made holder. It has a neat and discreet design, and keeps your device in an upright position for better reception. A cigarette lighter cable is permanently attached There is a cigarette lighter cable permanently attached to the back of this Holder. Because the connector is not on the bottom of the device, you will have to manually connect the cable. When the cable is not attached you can place it in the little holder attached on the side of the Holder. The Holder angles 15 degrees for optimal viewing. Easily slide your device in/out of the holder. No more fumbling around for your device. Provides for safer driving when viewing, accessing and operating your device in your vehicle.
About the Holder
Do you always need your battery fully charged? This Holder is the perfect solution for you! There is a cigarette lighter cable permanently attached to the back of this Holder. Because the connector is not on the bottom of the device, you will have to manually connect the cable. When the cable is not attached you can place it in the little “holder” attached on the side of the Holder.
The Holder is custom made to fit your device with grooves on the inside walls to match the thickness of the device. This will allow your device to slide freely in/out of the holder.
About Our Tilt Swivel
The Tilt Swivel on the back of the Holder can tilt 15 degrees in any direction and swivel 360 degrees. The Tilt Swivel provides easy adjustment of your handhelds position for better viewing, and extends the Holder from the Mount by 20mm / 0.78in. You can also adjust the Holder to avoid unnecessary light reflection. (The Holder shown in the picture to the left is attached to a demo ProClip Mount)
The Tilt Swivel Base Plate on the back of the Tilt Swivel can be attached to any flat surface or mounting brackett. The base plate comes with 6 pre-drilled holes; 2 holes in a center line and 4 holes in an almost square like pattern to accommodate the AMPS hole pattern. Enclosed in the packaging are 4 self tapping screws and 4 machine screws with nuts. Dimensions of base plate: 50mm/1.96inches x 42mm/1.65inches. The 4 holes in the corners have a diameter of 0.5mm, and the self tapping screw holes in the center have a diameter of 0.3mm.
Keep two devices on the same mount or use one at a time
If you have two devices you would like to have next to each other on your dashboard you may be able to have them on the same mount as shown in the General Picture to the left, by using our Horizontal Extension Plate. You can also move a device/holder from car to car (mount to mount) or switch between to devices/holders on the same mount by using our Move Clip System. Please see the product category, Mounting Options, to the left to learn more about these options.
Keep all your devices on the dashboard
If you have more than one device you would like to have on your dashboard, we may have the solution. Usually we have 2 or more mounts for each vehicle model so you can have all your devices securely attached on your dashboard. Many of todays customers order two or more mounts and holders - usually one for their mobile phone and one for their Handheld and/or Music Player like the General Picture below illustrates.
Unless you want to screw it directly into your car dashboard, you also need to order a Vehicle Mount.
The Vehicle Mount creates the platform you need for easy attachment of your device holder without damaging your dashboard. See illustration to the left. Learn More
The Vehicle Mount creates the platform you need for easy attachment of your device mount/holder.
Unless you have a holder from before (not windshield suction cup mount) we recommend you order a holder for your device to complete your mounting solution. See illustration to the left. Learn More
;)
;)
;)
;)
